How to Change Battery in 2018 Dodge Journey Key Fob
If you own a 2018 Dodge Journey, you may find yourself in a situation where you need to change the battery in your key fob. This is a common issue that can arise after some time, but it’s a relatively simple task that you can do yourself. In this article, we will guide you through the process of changing the battery in your 2018 Dodge Journey key fob.
Materials Needed
Before you begin, you will need to gather the following materials:
– A new CR2032 battery (you can find these at most electronics stores or online)
– A small flathead screwdriver
Step-by-Step Instructions
1.
Remove the key fob cover
First, locate the small tab on the back of the key fob. Use the flathead screwdriver to gently lift the tab and slide the cover off.
2.
Locate the battery
Once the cover is off, you will see the battery. It is usually located on the back of the key fob, near the center.
3.
Remove the old battery
Use the flathead screwdriver to carefully lift the battery out of its compartment. Be sure to hold the battery by its edges to avoid damaging it.
4.
Insert the new battery
Place the new CR2032 battery into the compartment, making sure that the positive (+) side is facing up. Gently press down on the battery until it is securely in place.
5.
Replace the cover
Slide the cover back onto the key fob and press down on it until it clicks into place.
6.
Test the key fob
To ensure that the battery change was successful, press the buttons on the key fob to test if it is working properly.
Conclusion
Changing the battery in your 2018 Dodge Journey key fob is a straightforward process that can be completed in just a few minutes. By following these simple steps, you can save yourself the time and expense of taking your key fob to a professional for repair. Just remember to keep a spare battery on hand for future use, and your key fob will continue to work smoothly for years to come.
